Vehicle part / Control arm (ZF Friedrichshafen AG) · LEMFÖRDER: 38526 01; TRW: JTC1619
Due to a production error, the connector inner sleeve of the recalled control arms, when fitted, may leave a gap which could permit further compression of the component during tightening. This can lead to stress in the…
Read the official notice →- Date
- 2025-05-23
- Country
- Germany
- Brand
- ZF Friedrichshafen AG
- Product
- Vehicle part / Control arm
- Classification
- injuries
- Category
- Vehicles
- Source
- EU Safety Gate
Copied automatically from the European Commission's Safety Gate. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the European Commission's Safety Gate has the exact models, batch codes and remedy, and it takes priority.
Other vehicles recalls in Germany
- 2025-05-30
DE
EU
Passenger car (Kia) · EV9
The mounting bolts for the first, second and/or third rows of seats may be missing, leading them to not properly restrain occupants, thereby increasing the risk of injury in the event of an accident. The product does…
- 2025-05-23
DE
EU
Bus (Mercedes-Benz) · TOURISMO
The floor bolting of the seating at the front of the vehicle may not have the correct torque in some cases, which is needed to anchor the seating securely to the floor. This leads to an increased risk of injury. The…
DE
EU
Passenger car (Bmw) · 1series, 2series (Active Tourer), 2series (Gran Coupé)
The front end may not be correctly bolted to the engine subframe. If one of the bolts has not been properly tightened and becomes detached, vehicle safety may be compromised in the event of a frontal collision. In this…
DE
EU
Passenger car (Mini) · COUNTRYMAN
The front end may not be correctly bolted to the engine subframe. If one of the bolts has not been properly tightened and becomes detached, vehicle safety may be compromised in the event of a frontal collision. In this…
DE
EU
Motorcycle (BMW Motorrad) · M1000R, M1000XR
A production fault may cause the jet needle to move out of the screw connection inside the steering damper. This may cause the steering to become heavy. This increases the risk of accidents and injuries. The product…
DE
EU
Passenger car (Ford) · Mustang
The incorrect calibration of the power steering control module (PSCM) could lead the steering wheel to oscillate without warning (alternating clockwise/counterclockwise) during steering due to the electric…