Altec Industries, Inc.: Turntable Fasteners Not Heat Treated
A fastener that has not been heat treated could fail, resulting in separation of the pedestal and turntable, increasing the risk of injury.
Read the official notice →- Date
- 2026-07-17
- Country
- United States
- Brand
- Altec Industries
- Product
- EQUIPMENT
- Units
- 309 affected
- Category
- Vehicles
- Source
- NHTSA
Copied automatically from the US National Highway Traffic Safety Administration. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the US National Highway Traffic Safety Administration has the exact models, batch codes and remedy, and it takes priority.
More Altec Industries recalls
- 2026-09-24
USAltec Industries, Inc.: Boom Stow Auto-Neutral System Improperly Wired
When the vehicle is moved or driven with the boom out of stow, the vehicle could exceed the recorded travel height, increasing the risk of a crash.
- 2026-08-27
- US
Altec Industries, Inc.: Strobe Light May Short Circuit
An electrical short circuit can increase the risk of a fire.
- 2026-08-21
- US
Altec Industries, Inc.: Automatic Brake System Improperly Calibrated
An improperly calibrated system may have a delayed braking response, increasing the risk of a crash.
- 2026-07-16
- US
Altec Industries, Inc.: Unprotected Boom Stow Wire May Short and Cause Fire
An overheated wire can ignite flammable material in the cargo area, increasing the risk of fire.
- 2026-07-02
- US
Altec Industries, Inc.: Incorrectly Routed Inverter AC Wiring May Short and Overheat
A short may cause the inverter AC wiring to overheat, increasing the risk of a fire.
- 2026-06-26
- US
Altec Industries, Inc.: Incorrect Pole Rack Capacity Rating
While using the pole rack at full capacity, an incorrect high vertical center of gravity during braking and cornering may lead to a loss of vehicle control, increasing the risk of a crash.
Other vehicles recalls in the United States
- 2026-07-20
- US
Blue Bird Body Company: Brake Fluid Leak May Cause Fire
A brake fluid leak in the presence of an ignition source such as hot engine or exhaust components can increase the risk of a fire. Additionally, a brake fluid leak can extend the distance required to stop, increasing…
- 2026-07-17
- US
Great Dane Trailers: Missing Rear Impact Guard Extension Channels/FMVSS 224
A rear impact guard that is not properly installed can increase the risk of injury during a crash.
- US
Foretravel, Inc.: Printed Circuit Board May Overheat
An overheated printed circuit board increases the risk of a fire.
- US
Turtle Top: Wheelchair Lift May Inadvertently Move
A wheelchair lift that continues to move while occupied increases the risk of injury.
- 2026-07-16
- US
International Motors, LLC: Body Panel Joints Incorrectly Attached/FMVSS 221
The body panels may separate during a crash, reducing structural integrity and increasing the risk of injury.
- US
International Motors, LLC: Body Panel Joints Incorrectly Attached/FMVSS 221
The body panels may separate during a crash, reducing structural integrity and increasing the risk of injury.