Altec Industries, Inc.: Boom Stow Auto-Neutral System Improperly Wired
When the vehicle is moved or driven with the boom out of stow, the vehicle could exceed the recorded travel height, increasing the risk of a crash.
Read the official notice →- Date
- 2026-09-24
- Country
- United States
- Brand
- Altec Industries
- Product
- ELECTRICAL SYSTEM
- Units
- 143 affected
- Category
- Vehicles
- Source
- NHTSA
Copied automatically from the US National Highway Traffic Safety Administration. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the US National Highway Traffic Safety Administration has the exact models, batch codes and remedy, and it takes priority.
More Altec Industries recalls
- 2026-10-09
USAltec Industries, Inc.: Missing Rearview Camera
A missing rearview camera can reduce the driver's view behind the vehicle, increasing the risk of a crash.
- US
Altec Industries, Inc.: Front Bumper May Detach
A front bumper that detaches can become a road hazard and increase the risk of a crash. In addition, the bolts can fail suddenly during winch operation, increasing the risk of injury.
- 2026-10-02
- US
Altec Industries, Inc.: Platform Access Step May Separate from Vehicle
A step that separates or becomes unstable while in use, increases the risk of a fall or injury.
- 2026-08-27
- US
Altec Industries, Inc.: Strobe Light May Short Circuit
An electrical short circuit can increase the risk of a fire.
- 2026-08-21
- US
Altec Industries, Inc.: Automatic Brake System Improperly Calibrated
An improperly calibrated system may have a delayed braking response, increasing the risk of a crash.
- 2026-07-17
- US
Altec Industries, Inc.: Turntable Fasteners Not Heat Treated
A fastener that has not been heat treated could fail, resulting in separation of the pedestal and turntable, increasing the risk of injury.
Other vehicles recalls in the United States
- 2026-09-28
- US
Volvo Trucks North America: Software Calculation Error May Cause Reduced Braking Performance
Reduced braking performance can require a greater distance to stop, increasing the risk of a crash.
- US
Cummins, Inc.: Fuel Filter Hoses May Disconnect and Leak Fuel
A fuel leak in the presence of an ignition source increases the risk of a fire. An engine stall increases the risk of a crash.
- 2026-09-25
- US
Aluminum Trailer Company (ATC): Coupler May Separate from Trailer
A separated trailer coupler can cause a loss of control and increase the risk of a crash.
- 2026-09-24
- US
Grand Design RV, LLC: Solar Controller May Select Incorrect Voltage Output
While damage to the power center increases the risk of a fire, damage to the electrical system may cause the trailer brakes or exterior lightings to fail, increasing the risk of a crash.
- US
Jaguar Land Rover North America, LLC: Seat Belt May Be Improperly Stitched
An improperly stitched seat belt may fail to properly restrain an occupant during a crash, increasing the risk of injury.
- US
Jaguar Land Rover North America, LLC: Rear Subframe May Crack
A cracked subframe may have reduced structural integrity, increasing the risk of injury during a crash. A crack may also diminish handling and control, increasing the risk of a crash.