Altec Industries, Inc.: Incorrect Pole Rack Capacity Rating
While using the pole rack at full capacity, an incorrect high vertical center of gravity during braking and cornering may lead to a loss of vehicle control, increasing the risk of a crash.
Read the official notice →- Date
- 2026-06-26
- Country
- United States
- Brand
- Altec Industries
- Product
- EQUIPMENT
- Units
- 6 affected
- Category
- Vehicles
- Source
- NHTSA
Copied automatically from the US National Highway Traffic Safety Administration. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the US National Highway Traffic Safety Administration has the exact models, batch codes and remedy, and it takes priority.
More Altec Industries recalls
- 2026-07-17
USAltec Industries, Inc.: Turntable Fasteners Not Heat Treated
A fastener that has not been heat treated could fail, resulting in separation of the pedestal and turntable, increasing the risk of injury.
- 2026-07-16
- US
Altec Industries, Inc.: Unprotected Boom Stow Wire May Short and Cause Fire
An overheated wire can ignite flammable material in the cargo area, increasing the risk of fire.
- 2026-07-02
- US
Altec Industries, Inc.: Incorrectly Routed Inverter AC Wiring May Short and Overheat
A short may cause the inverter AC wiring to overheat, increasing the risk of a fire.
- 2026-06-12
- US
Altec Industries, Inc.: Transmission Park Interlock May Be Missing
An aerial device that operates while the vehicle is in gear or neutral can cause unexpected vehicle movement and increase the risk of injury.
- 2026-06-11
- US
Altec Industries, Inc.: Missing Welds on Personnel Jib Platform
Missing welds can lead to platform joint failure due to fatigue or overload, resulting in the platform falling from the boom tip, increasing the risk of injury.
- 2026-05-15
- US
Altec Industries, Inc.: Emergency Stop May Fail
Hydraulic functions that do not immediately stop when the ground level E-stop is pressed, increase the risk of injury.
Other vehicles recalls in the United States
- 2026-06-29
- US
Tiffin Motorhomes, Inc.: Printed Circuit Board May Overheat
An overheated printed circuit board increases the risk of a fire.
- US
Jayco, Inc.: Incorrect Weight Information on OCCC Label/FMVSS 120
Referencing incorrect weight information may lead to unintentionally overloading the vehicle, increasing the risk of a crash.
- 2026-06-26
- US
Nissan North America, Inc.: Incorrectly Installed Driveshaft
An unexpected loss of drive power can increase the risk of a crash. In addition, a driveshaft that is not fully engaged can result in a vehicle rollaway if the parking brake is not applied, increasing the risk of a…
- US
Daimler Trucks North America, LLC: Entrance Door May Fail to Open or Close
A door that fails to open or close increases the risk of injury to occupants in a crash.
- US
Daimler Trucks North America, LLC: Entrance Door May Fail to Open or Close
A door that fails to open or close increases the risk of injury to occupants in a crash.
- US
Diamond Coach Corporation: Wheelchair Restraint Retractor May Not Lock
An unsecured wheelchair can move during transit, increasing the risk of injury.