Altec Industries, Inc.: Missing Welds on Personnel Jib Platform
Missing welds can lead to platform joint failure due to fatigue or overload, resulting in the platform falling from the boom tip, increasing the risk of injury.
Read the official notice →- Date
- 2026-06-11
- Country
- United States
- Brand
- Altec Industries
- Product
- EQUIPMENT
- Units
- 14 affected
- Category
- Vehicles
- Source
- NHTSA
Copied automatically from the US National Highway Traffic Safety Administration. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the US National Highway Traffic Safety Administration has the exact models, batch codes and remedy, and it takes priority.
More Altec Industries recalls
- 2026-07-02
USAltec Industries, Inc.: Incorrectly Routed Inverter AC Wiring May Short and Overheat
A short may cause the inverter AC wiring to overheat, increasing the risk of a fire.
- 2026-06-26
- US
Altec Industries, Inc.: Incorrect Pole Rack Capacity Rating
While using the pole rack at full capacity, an incorrect high vertical center of gravity during braking and cornering may lead to a loss of vehicle control, increasing the risk of a crash.
- 2026-06-12
- US
Altec Industries, Inc.: Transmission Park Interlock May Be Missing
An aerial device that operates while the vehicle is in gear or neutral can cause unexpected vehicle movement and increase the risk of injury.
- 2026-05-15
- US
Altec Industries, Inc.: Emergency Stop May Fail
Hydraulic functions that do not immediately stop when the ground level E-stop is pressed, increase the risk of injury.
- 2026-04-17
- US
Altec Industries, Inc.: Improperly Installed Front End Radar
While driving, the brakes may activate unexpectedly without the driver's input, increasing the risk of a crash.
- 2026-04-16
- US
Altec Industries, Inc.: Inoperative Emergency Stop Switch
An inoperative emergency stop switch increases the risk of injury.
Other vehicles recalls in the United States
- 2026-06-12
- US
Altec Industries, Inc.: Transmission Park Interlock May Be Missing
An aerial device that operates while the vehicle is in gear or neutral can cause unexpected vehicle movement and increase the risk of injury.
- US
Winnebago Industries, Inc.: Incorrect Tire Size Information on Label/FMVSS 110
Referencing the incorrect information could cause owners to install the wrong size replacement tires, increasing the risk of a crash.
- US
Marion Body Works Inc.: Liftgate Deck Pins May Break
A liftgate that falls unexpectedly increases the risk of injury.
- 2026-06-11
- US
Great Dane Trailers: Liftgate Deck Pins May Break
A liftgate that falls unexpectedly increases the risk of injury.
- US
International Motors, LLC: Delayed Brake Release/FMVSS 121
A delayed brake release can increase the risk of crash.
- US
Yamaha Recalls UMAX Bistro and Bistro Deluxe Vehicles Due to Injury Hazard
The recalled Bistro and Bistro Deluxe vehicles have an inaccurate weight capacity certification label. This could result in the vehicle being overloaded, which poses an injury hazard.