Terex South Dakota, Inc.: Cracked Weld May Cause Pole Guide Arm to Fall
Without a retaining pin, the pole guide arm may fall, increasing the risk of injury to people around the truck.
Read the official notice →- Date
- 2026-03-30
- Country
- United States
- Brand
- Terex South Dakota
- Classification
- Equipment
- Units
- 3,015 affected
- Category
- Vehicles
- Source
- NHTSA
Copied automatically from the US National Highway Traffic Safety Administration. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the US National Highway Traffic Safety Administration has the exact models, batch codes and remedy, and it takes priority.
More Terex South Dakota recalls
- 2026-03-19
USTerex South Dakota, Inc.: Cracked Weld May Cause Pole Guide Arm to Fall
Without a retaining pin, the pole guide arm may fall, increasing the risk of injury to people around the truck.
- 2026-01-12
- US
Terex South Dakota, Inc.: Hydraulic Equipment May Overheat
Touching parts of the overheated hydraulic equipment can increase the risk of burn injuries.
- 2024-10-03
- US
Terex South Dakota, Inc.: Jib Extension Cylinder Rod Weld Can Fail
A failed weld can result in the cylinder rod separating from the cylinder, increasing the risk of injury.
- 2024-07-11
- US
Terex South Dakota, Inc.: Boom Basket Retaining Pin Failure
Tilting of the basket may cause the basket occupants to fall, increasing the risk of an injury.
- 2024-06-13
- US
Terex South Dakota, Inc.: Controller May Fail to Keep Platform Level
A platform that cannot maintain a level position increases the risk of injury.
- 2024-01-25
- US
Terex South Dakota, Inc.: Boom Rotation Bearing Bolts Not Tightened Properly
Improperly tightened boom rotation bearing bolts may fail, causing the boom to fall, and increasing the risk of injury.
Other vehicles recalls in the United States
- 2026-03-31
- US
Ford Motor Company: Front Passenger Air Bag May Not Deploy/FMVSS 208
Failure to correctly detect a passenger may result in the air bag not deploying as intended, increasing the risk of injury during a crash.
- US
Ricon Corporation: PTSB Gear Motor May Fail to Lock Seat In Place/FMVSS 207
A seat that moves may not properly restrain the occupant during a crash, increasing the risk of injury.
- 2026-03-30
- US
Aston Martin The Americas: Rear Lower Suspension Arm Failure
Failure of the rear lower suspension arm can cause a loss of vehicle control, damage the brake line or other suspension components, and increase the risk of a crash.
- 2026-03-27
- US
Mercedes-Benz USA, LLC: Air Bag May Not Deploy as Intended
Air bags that do not deploy as intended during a crash increase the risk of injury.
- US
Mercedes-Benz USA, LLC: Loose Wheel Bolts
Incorrect wheel bolts can allow a wheel to loosen or detach from the vehicle, increasing the risk of a crash.
- US
Yamaha Motor Corporation, USA: Do Not Ride: Speedometer Failure
Speedometer failure increases the risk of a crash.