Terex South Dakota, Inc.: Cracked Weld May Cause Pole Guide Arm to Fall
Without a retaining pin, the pole guide arm may fall, increasing the risk of injury to people around the truck.
Read the official notice →- Date
- 2026-03-19
- Country
- United States
- Brand
- Terex South Dakota
- Units
- 2,303 affected
- Category
- Vehicles
- Source
- NHTSA
Copied automatically from the US National Highway Traffic Safety Administration. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the US National Highway Traffic Safety Administration has the exact models, batch codes and remedy, and it takes priority.
More Terex South Dakota recalls
- 2026-03-30
USTerex South Dakota, Inc.: Cracked Weld May Cause Pole Guide Arm to Fall
Without a retaining pin, the pole guide arm may fall, increasing the risk of injury to people around the truck.
- 2026-01-12
- US
Terex South Dakota, Inc.: Hydraulic Equipment May Overheat
Touching parts of the overheated hydraulic equipment can increase the risk of burn injuries.
- 2024-10-03
- US
Terex South Dakota, Inc.: Jib Extension Cylinder Rod Weld Can Fail
A failed weld can result in the cylinder rod separating from the cylinder, increasing the risk of injury.
- 2024-07-11
- US
Terex South Dakota, Inc.: Boom Basket Retaining Pin Failure
Tilting of the basket may cause the basket occupants to fall, increasing the risk of an injury.
- 2024-06-13
- US
Terex South Dakota, Inc.: Controller May Fail to Keep Platform Level
A platform that cannot maintain a level position increases the risk of injury.
- 2024-01-25
- US
Terex South Dakota, Inc.: Boom Rotation Bearing Bolts Not Tightened Properly
Improperly tightened boom rotation bearing bolts may fail, causing the boom to fall, and increasing the risk of injury.
Other vehicles recalls in the United States
- 2026-03-20
- US
Altec Industries, Inc.: Chassis Lighting Harness Not Installed
Loss of body lighting or trailer lights increases the risk of a crash.
- US
Hyundai Motor America: Seat Belt Status Indicator Malfunction
A faulty seat belt status indicator may fail to alert occupants to an unfastened seat belt, increasing the risk of injury.
- 2026-03-19
- US
International Motors, LLC: Body Panel Joint Incorrectly Attached/FMVSS 221
The body panels may separate during a crash, reducing structural integrity and increasing the risk of injury.
- US
General Motors, LLC: Roof Rail Air Bag Inflator Endcap May Detach
A detached end cap or inflator rupture can allow compressed gas to escape and project the end cap or fragments of the inflator into the vehicle, increasing the risk of injury.
- US
Ford Motor Company: Loss of Rearview Camera Image and ADAS Features
Loss of the rearview camera image and certain driver assistance features, can reduce the driver’s ability to detect hazards, increasing the risk of a crash.
- US
Lippert: Incorrect Seal Used on Axle During Assembly
A loss of lubrication can cause bearing failure and wheel loss, increasing the risk of a crash.