Altec Industries, Inc.: Pedestal and Truck Frame May Separate
A broken side plate may result in pedestal and truck frame separation, increasing the risk of injury.
Read the official notice →- Date
- 2021-11-15
- Country
- United States
- Brand
- Altec Industries
- Product
- EQUIPMENT
- Units
- 4,055 affected
- Category
- Vehicles
- Source
- NHTSA
Copied automatically from the US National Highway Traffic Safety Administration. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the US National Highway Traffic Safety Administration has the exact models, batch codes and remedy, and it takes priority.
More Altec Industries recalls
- 2022-03-11
USAltec Industries, Inc.: Missing Carbon Monoxide Detectors
Elevated levels of carbon monoxide gas may not be detected, increasing the risk of injury.
- 2022-02-09
- US
Altec Industries, Inc.: Over-Tightened Bolts in Rotation Bearing
Broken bolts can cause separation of the pedestal and turntable, increasing the risk of injury.
- US
Altec Industries, Inc.: Shear Plates May Fail
Shear plate failure can result in the separation of the subbase and truck frame, increasing the risk of injury.
- 2022-02-03
- US
Altec Industries, Inc.: Boom May Move in an Unintended Direction
The boom moving in an unintended direction increases the risk of injury.
- US
Altec Industries, Inc.: Bolt Failure May Cause Pedestal Separation
Broken bolts can cause the pedestal to separate from the turntable, increasing the risk of injury.
- 2021-12-20
- US
Altec Industries, Inc.: Incorrect Hydraulic Plumbing to Lift Cylinders
The operator could overextend the boom while using the material handling jib, causing the aerial device to tip over and increasing the risk of injury.
Other vehicles recalls in the United States
- 2021-11-16
- US
M H EBY: Missing Conspicuity Tape/FMVSS 108
Missing white conspicuity tape reduces the vehicle's visibility to other drivers, increasing the risk of a crash.
- US
Jayco, Inc.: Rear Suspension Fasteners Not Tightened Properly
Loose or broken suspension fasteners can allow the rear-drive axle to shift out of place, increasing the risk of a crash.
- US
Jayco, Inc.: Broken Shaft Seal May Cause Loss of Power Steering
A loss of power steering assist increases the risk of a crash.
- 2021-11-12
- US
Timpte, Inc.: iABS Securing Screws Improperly Tightened
Pressure loss in the iABS unit can cause a loss of brake function, increasing the risk of a crash.
- US
Daimler Trucks North America, LLC: Power Stud May Electrically Arc to Bulkhead
An electrical arc can increase the risk of a fire.
- US
Volvo Car USA, LLC: Missing Cross-Member Bolt in Engine Compartment
A loose or missing bolt may decrease the structural protection of the vehicle, increasing the risk of injury during a crash.