Passenger car (Peugeot) · 208 V2, 2008 V2
The vehicle may have contact, or insufficient clearance (< 10 mm), between the petrol particulate filter pipe and the terminal protection cap of the 48 V belt starter generator. In wet conditions, the insufficient…
Read the official notice →
- Date
- 2026-03-20
- Country
- France
- Brand
- Peugeot
- Product
- Passenger car
- Classification
- fire
- Category
- Vehicles
- Source
- EU Safety Gate
Copied automatically from the European Commission's Safety Gate. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the European Commission's Safety Gate has the exact models, batch codes and remedy, and it takes priority.
More Peugeot recalls
- 2026-04-24
DE
EUPassenger van (Peugeot) · PARTNER, RIFTER
Vehicles without a bulkhead were manufactured and supplied with a single instead of a double seatback. There is a risk of excessive movement of the seatback in the event of a rear-end collision, which could result in…
FREUPassenger car (Peugeot) · Rifter, Partner
In vehicles fitted with a DV5 diesel engine, the NOx sensor may not have been properly tightened during installation. This may allow exhaust gases to enter the engine compartment and could result in visible exhaust…
- 2026-04-03
- FREU
Passenger car / Passenger van (Peugeot) · 208 V2, 308 V3, Rifter, Partner, Expert
The DV5R engine may experience a loss of power due to slippage of the water pump pulley. This slippage can cause misalignment of the timing belt, potentially resulting in engine shutdown. The sprocket of the water pump…
- 2026-02-20
- FREU
Light commercial vehicle (Peugeot) · Boxer NG
There is an insufficient connection between the fuel return pipe and the valve which could lead to a fuel leak. The possibility of fuel coming into contact with hot parts cannot be ruled out, which could cause the…
- 2026-02-13
- FREU
Passenger car (Peugeot) · 3008 V3, 5008 V3
The wheel nuts are not securely tightened, which could result in the wheel nut coming loose while the vehicle is in motion, or the loss of a wheel. This could result in an accident and injuries. The product does not…
- 2026-02-06
- FREU
Passenger car / Light commercial vehicle (Peugeot) · 308 V3, Rifter, Partner, Expert
Vehicles fitted with a DV5R engine may experience a fuel leak. The non-conformity of the round shape on the cone of the common rail may cause the nut to loosen, resulting in the possibility of fuel leaking between the…
Other vehicles recalls in France
- 2026-03-27
- FREU
Passenger car (CITROEN) · C3 Aircross V3, C3 V5, C4 V3, C4X
There is insufficient clearance (< 10 mm), between the tube of the petrol particulate filter and the terminal protection cap of the 48 V belt-driven starter alternator. In wet conditions, the insufficient clearance and…
- FREU
Passenger car (Lancia) · Ypsilon
There is insufficient clearance (< 10 mm), between the tube of the petrol particulate filter and the terminal protection cap of the 48 V belt-driven starter alternator. In wet conditions, the insufficient clearance and…
- FREU
Vehicle part/Tyre (Michelin) · 205/60R16 92H MICHELIN PRIMACY 5 ENERGY - CAI 847036
The residual thickness of the inner liner, which contributes to airtightnes is insufficient. This can lead to an abnormal, slow pressure loss, potentially affecting the stability of the car and causing a risk of…
- 2026-03-20
- FREU
Passenger car (Opel/Vauxhall) · Corsa, Frontera, Mokka
The vehicle may have contact, or insufficient clearance (< 10 mm), between the petrol particulate filter pipe and the terminal protection cap of the 48 V belt starter generator. In wet conditions, the insufficient…
- FREU
Passenger car (Renault) · RENAULT 5 - R4 E-Tech
A production anomaly at the supplier’s facility may cause delamination of the anode in a battery cell, where electrode material detaches and can damage the current collector and separator, potentially leading to an…
- 2026-03-13
- FREU
Passenger car (Renault) · CLIO V
The tightening of the ball joint nuts of the front lower control arm may be insufficient due to a processing defect. The first signs thereof are an abnormal noise (clicking and/or knocking sounds) detected at low…