Passenger car (Bmw) · iX3
The convenience charging electronics module may have a manufacturing fault. If the module fails during charging, electrical current may flow through the vehicle body. As a result, touching the vehicle body could expose…
Read the official notice →
- Date
- 2026-08-25
- Country
- Germany
- Brand
- BMW
- Product
- Passenger car
- Classification
- electric shock
- Category
- Vehicles
- Source
- EU Safety Gate
Copied automatically from the European Commission's Safety Gate. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the European Commission's Safety Gate has the exact models, batch codes and remedy, and it takes priority.
More BMW recalls
- 2026-10-07
USBMW of North America, LLC: Reverse Gear Control Unit May Overheat
An overheated reverse gear control unit increases the risk of a fire.
- 2026-09-15
DE
EUPassenger car (Bmw) · 3 series, 5 series, 7 series
Water may enter the starter motor and cause damage. As a result, the engine may no longer start, or the starter motor may short-circuit or remain continuously activated. This could cause local overheating of the…
- 2026-08-12
- US
BMW of North America, LLC: Loss of Rear Wheel Power from Driveshaft Damage
An unexpected loss of drive power can increase the risk of a crash. In addition, a damaged driveshaft can result in a vehicle rollaway if the parking brake is not applied, increasing the risk of a crash or injury.
- US
BMW of North America, LLC: Incorrectly Attached Steering Spindle
An incorrectly attached steering spindle can lead to a loss of steering control, increasing the risk of a crash.
- 2026-08-04
FREUPassenger car (Bmw) · Series 2, Series 3, Series 4, Series 5, Series 6, Series 7, X3, X4, X5, X6, Z4
The RSW22 starter with reinforced water tightness (RWT) may experience increased abrasion of the magnetic contact, causing deposits to build up at the lowest point inside the relay. These deposits may increase relay…
- 2026-07-23
- US
BMW of North America, LLC: Ignition Lock May Fail and Cause Engine Stall
An engine stall or failure of electrical systems such as the instrument display or ABS, increases the risk of a crash.
Other vehicles recalls in Germany
- 2026-09-09
- DEEU
Electric bicycle (Stromer) · ST3, ST5, ST7
The front steerer tube can wear out prematurely and fracture, break or open during use. As a result, the driver may lose control of the bike, therefore increasing the risk of injury.
- 2026-09-03
- DEEU
Passenger car (Mercedes-Benz) · GLE-Class
In certain GLE series vehicles (model series 167) with OM654 and hybrid engines, a shielding plate in the bulkhead area may not have been fitted according to specifications. As a result, the fuel line could rub against…
- 2026-08-26
- DEEU
Passenger car (Porsche) · Taycan
A combination of production issues (such as a torn anode tab, a folded cathode tab, a peeled-off cathode or a double production topic pouch crack) was found in some of the batteries' high-voltage modules. Over the…
- 2026-08-21
- DEEU
Motorcycle (HARLEY-DAVIDSON) · Heritage Classic, Street Bob, Low Rider S, Low Rider ST
The rear brake line may rub against the body control module and develop a leak. This could reduce rear-wheel braking performance, increasing the risk of an accident and injury. The product does not comply with the…
- 2026-08-14
- DEEU
Bus (Setra) · S 531 DT
Manufacturing errors in the production of steering components may reduce their fatigue strength and make them susceptible to breakage. If a component breaks, the steering system may fail, increasing the risk of an…
- 2026-08-13
- DEEU
Passenger car (Audi) · Q3
A joint on the pyrotechnic gas generator in the front seat belt pretensioners may not have been properly welded. In the event of an accident, small parts could detach, increasing the risk of injury to passengers.