Motorcycle tyre (Dunlop) · PRO Medium 120/80-12 55J TT93GP
The tyre may have a thin layer of compound covering the tread surface. This condition can reduce grip, increasing the risk of motorcycle accidents and injuries. This product does not comply with the Regulation on the…
Read the official notice →- Date
- 2025-08-29
- Country
- Luxembourg
- Brand
- Dunlop
- Product
- Motorcycle tyre
- Classification
- injuries
- Category
- Vehicles
- Source
- EU Safety Gate
Copied automatically from the European Commission's Safety Gate. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the European Commission's Safety Gate has the exact models, batch codes and remedy, and it takes priority.
More Dunlop recalls
- 2024-12-06
DE
EU
Mobile phone armband (Dunlop) · Sportarmband für Smartphone
The back of the armband has an excessive concentration of polycyclic aromatic hydrocarbons (PAHs), notably benzo[a]pyrene, benzo[e]pyrene and benzo[a]anthracene (measured values: 2.82 mg/kg, 4.73 mg/kg and 2.93 mg/kg…
- 2023-12-22
LU
EU
Motorcycle tyre (Dunlop) · Sportmax Roadsmart III
A manufacturing defect could lead to a tread separation. This could lead to the loss of control over the motorcycle, increasing the risk of an accident. The product does not comply with the Regulation on the approval…
- 2023-11-03
LU
EU
Bicycle helmet (Dunlop) · Bicycle helmet / casque de vélo
The shock-absorbing capacity of the helmet is insufficient. As a result, the user might suffer injuries in case of an impact. The product does not comply with the Personal Protective Equipment Regulation nor with the…
- 2022-01-07
LU
EU
Motorcycle tyre (Dunlop) · Dunlop KR106 MS3 TL
The tyres are affected by a manufacturing variation. If a person accelerating on a motorbike with the defective tyre the person will loses balance and may fall. The product does not comply with the requirements of…
Other vehicles recalls in Luxembourg
- 2026-05-01
LU
EU
Vehicle part / Tyre (Goodyear) · Eagle F1 SUPERSPORT XL
At extremely high speeds a separation within the crown area of the tyre is possible. The tyre tread could deform with a local increase of diameter and could create interference with the car. This condition could cause…
- 2025-11-14
LU
EU
Truck tyre (Goodyear) · 295/80R22.5 152/148M KMAX D Gen2
Some tyres are affected by a manufacturing variation that results in a thin liner condition, which may lead to air pressure loss, causing a loss of vehicle control and increasing the risk of injury. The product does…
- 2025-09-05
LU
EU
Vehicle part / Car tyre (Fulda) · ECOCONTROL HP2 XL
A manufacturing variation can result in tread deformation, which may lead to a loss of vehicle control, increasing the risk of accidents and injuries. The product does not comply with the Regulation on the approval and…
- 2025-04-25
LU
EU
Vehicle part / Car tyre (Goodyear) · 225/45R17 94Y Eagle F1 Asymmetric 6
A manufacturing variation can result in tread deformation or crown separation, which may lead to a loss of vehicle control, increasing the risk of accidents and injuries. The product does not comply with the Regulation…
- 2025-01-10
LU
EU
Motorcycle tyre (Avon, Dunlop) · Several models of motorcycle tyres
A contamination located under the tread can lead to a lower tread adhesion and to tread separation. This can cause the loss of control of the motorcycle, increasing the risk of accidents and injuries. The product does…
- 2024-11-29
LU
EU
Passenger car (Infiniti) · Q50, M30, Q70
The propeller shafts have insufficient strength due to insufficient press-fitting length of the universal joints into the tubes. As a result, cracks can develop in these areas during use, leading the propeller shaft to…