Motorcycle (Honda) · CBR 1000 SPL/STL
If driven on the 1st gear and at high RPM, the surface of the resin h hose of the oil cooler may over-heat from the radiant heat of the exhaust pipe. The resin hose may crack and engine oil may leak. This may cause a…
Read the official notice →- Date
- 2022-02-18
- Country
- Portugal
- Brand
- Honda
- Product
- Motorcycle
- Classification
- injuries
- Category
- Vehicles
- Source
- EU Safety Gate
Copied automatically from the European Commission's Safety Gate. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the European Commission's Safety Gate has the exact models, batch codes and remedy, and it takes priority.
More Honda recalls
- 2022-05-26
USHonda (American Honda Motor Co.): Inaccurate Fuel Gauge Reading
An inaccurate fuel gauge may result in the vehicle unexpectedly running out of fuel and stalling, increasing the risk of a crash.
- 2022-04-29
DE
EUPassenger car (Honda) · Accord, Acura, Fit, Civic
The drive shafts installed in the vehicles concerned were coated with a lubricant which accelerates the wearing of the protective layer covering them, making them more susceptible to damage caused by road debris.…
- 2022-03-18
- DEEU
Passenger car (Honda) · Passport, Pilot, Ridgeline
At high speeds, the air inlet between the bonnet and the radiator grill causes vibrations in the hood. This can result in stress fractures along the bonnet latch striker and its separation from the bonnet, causing the…
- 2022-02-03
- US
Honda (American Honda Motor Co.): Oil Leak from Melted Oil Cooler Pipe
A ruptured oil cooler pipe can leak oil onto the exhaust pipe or rear tires, increasing the risk of a fire, crash, or injury.
- 2021-12-24
PTEUMotorcycle (Honda) · CBR1000STL/SPL ; CMX1100AM/DM
Due to a manufacturing error, the motorcycle may have insufficient sealant performance due to small overlap allowance with the filler neck in the cooling system of the engine. If the vehicle is used continuously in…
- 2021-12-16
- US
Honda (American Honda Motor Co.): Radiator Cap May Leak or Spray Hot Coolant
An insufficiently sealed radiator cap may leak or spray hot coolant, increasing the risk of injury or crash.
Other vehicles recalls in Portugal
- 2022-04-29
- PTEU
Passenger car (Lexus) · NX
Certain spot-welds were missed during the welding of the body panels to the left and right front shock absorbers.As a result, cracks and breakage may occur on other spot-welds and/or on the body panels around the front…
- 2022-03-25
- PTEU
Passenger car (Toyota) · C-HR, GR Yaris, Yaris.
The radar sensor may malfunction due to a faulty installation. This can result in a failure to detect a vehicle in front through the PCS (pre-collision system), which will not provide warnings or brake assistance and…
- PTEU
Passenger car (Renault) · Arkana
Due to a faulty calibration of the electronic power steering computer, overheating may occur. This can lead to a possible loss of steering management assistance, increasing the risk of an accident. The product does not…
- 2022-01-28
- PTEU
Passenger car (Mazda) · 2 (DJ), 3 (BM/BN), 6 (GJ/GL), CX-3 (DK), CX-5 (KE/KF), CX-9 (TB) , MX-5 (ND)
The impeller in the low-pressure fuel pump may become deformed causing fuel pomping failure. This may result in the engine no start and/or stall, increasing the risk of an accident. The product does not comply with the…
- 2022-01-14
- PTEU
Passenger car (Hyundai) · IONIQ (AE EV)
The vehicle may enter a “fail-safe” mode, causing the EV Ready lamp to flash, accompanied with reduced acceleration and over all power output, which increases the risk of an accident. The product does not comply with…
- 2021-12-24
- PTEU
Motorcycle (Honda) · CBR1000STL/SPL ; CMX1100AM/DM
Due to a manufacturing error, the motorcycle may have insufficient sealant performance due to small overlap allowance with the filler neck in the cooling system of the engine. If the vehicle is used continuously in…