Iowa Mold Tooling Co., Inc.: Stabilizer Beam Welds May Crack
A broken stabilizer beam can cause the vehicle to tip, or disengage the load, increasing the risk of injury.
Read the official notice →- Date
- 2023-05-31
- Country
- United States
- Brand
- Iowa Mold Tooling
- Classification
- Equipment
- Units
- 13 affected
- Category
- Vehicles
- Source
- NHTSA
Copied automatically from the US National Highway Traffic Safety Administration. Details may be shortened or out of date; the official notice is the authoritative source. Disclaimer
What to do
- Check whether your vehicle is affected by entering its VIN (vehicle identification number) on the manufacturer's or the agency's recall lookup.
- Contact a dealer to book the repair. Recall repairs are normally free of charge.
- If the notice says not to drive or to park outside, follow that until the repair is done.
General guidance from Recall Atlas. The official notice from the US National Highway Traffic Safety Administration has the exact models, batch codes and remedy, and it takes priority.
More Iowa Mold Tooling recalls
- 2022-08-15
US
Iowa Mold Tooling Co., Inc.: Stabilizer Beam Welds May Crack Over Time
A cracked or broken stabilizer beam can cause the vehicle to tip, or disengage the load, increasing the risk of injury.
Other vehicles recalls in the United States
- 2023-05-31
US
Triple E Recreational Vehicles: 2-Stage Regulator May Leak Propane
A gas leak in the presence of an ignition source increases the risk of a fire.
US
Bentley Motors, Inc.: Second Row Seats Incorrectly Installed
An unlocked seat rail can move in the event of a crash, increasing the risk of injury to occupants.
US
Marion Body Works Inc.: Fire Truck Water Pump May Fail
A fire truck that is unable to pump water increases the risk of injury during a fire.
- 2023-05-30
US
Tesla, Inc.: Steering Wheel May Disconnect from Steering Column
A loose fastener may allow the steering wheel to disconnect from the steering column, which can cause a loss of steering control and increase the risk of a crash.
US
Toyota Motor Engineering & Manufacturing: Air Bag May Not Deploy Properly/FMVSS 208
An air bag that does not deploy as intended increases the risk of injury during a crash.
US
Wabash National Corporation: Improperly Welded King Pin
Unintentional movement of a detached king pin may cause a loss of trailer control, increasing the risk of a crash.